Nitrocellulose Membrane Roll

B5003m x 30cm Roll


DescriptionNitrocellulose is the most commonly used membrane in immunoblotting and nucleic acid detection methods. Owing to its high affinity for proteins and nucleic acid, nitrocellulose serves as an excellent binding matrix and is used in a wide range of molecular applications, including western, northern and southern blotting techniques. abm’s 0.22 µm pore-size nitrocellulose membrane is available in two formats; the pre-cut sheets are easy to use and convenient while the economic roll format offers the option of custom membrane sizing by the end user.

Key Features:
User Friendly - Compatible with standard immunoblotting and nucleic acid detection methods.
High-binding affinity - Provides outstanding binding capacity without background interference and gives high signal-to-noise ratio.
Convenient options - Available in two formats:
- Convenient pre-cut membrane packs
- Economical rolls
Applications• Transfer of protein from SDS-PAGE gel to membrane in preparation for western blotting.
• Transfer of nucleic acids in preparation for northern or southern blotting.
• Immunodetection of target proteins such as dot-blot assay and probe hybridization of nucleic acids.
Unit quantity3m x 30cm Roll
Storage ConditionStore at room temperature.

Supporting Protocol





          I would like to know under what circumstance I could have no signal?
          Here are some suggestions and how you could resolve the problem: 1. The primary antibody and the secondary antibody are not compatible. Use secondary antibody that was raised against the species in which the primary was raised (e.g primary is raised in rabbit, use anti-rabbit secondary). 2. Not enough primary or secondary antibody is bound to the protein of interest. Use more concentrated antibody. Incubate longer (e.g. overnight) at 4ºC. 3. Cross-reaction between blocking agent and primary or secondary antibody. Use a mild detergent such as Tween20 or switch blocking reagent (i.e. commonly used blocking reagentsare milk, BSA, serum or gelatin). 4. The primary antibody does not recognize the protein in the species being tested. Check the datasheet or perform a ClustalW alignment to ensure your antibody should react with the target protein; Run the recommended positive control. 5. Insufficient antigen. Load at least 20-30 ug protein per lane; Use protease inhibitors; Run the recommended positive control. 6. The protein of interest is not abundantly present in the tissue. Use an enrichment step to maximize the signal (e.g. prepare nuclear lysates for a nuclear protein, etc.). 7. Poor transfer of protein to membrane. Check the transfer with a reversible stain such as Ponceau S; check that the transfer was not performed the wrong way; if using PVDF membrane make sure you pre-soak the membrane in MeOH then in transfer buffer. 8. Excessive washing of the membrane. Do not over wash the membrane. 9. Too much blocking does not allow you to visualize your protein of interest. Instead of using 5% milk in the antibody buffers try removing the milk or using 0.5%; Switch blocking reagents or block for less time. 10. Over-use of the primary antibody. Use fresh antibody as the effective concentration is lowered upon each re-use. 11. Secondary antibody inhibited by sodium azide. Do not use sodium azide together with HRP-conjugated antibodies. 12. Detection kit is old and substrate is inactive. Use fresh substrate.

          There are no references for this product yet!